NEVER use the “no exec-timeout” command!

When configuring a cisco router or switch, you may have been told that you can stop your console or telnet sessions from timing out by using the following configuration:

line con 0  !(or line vty 0 4)
 no exec-timeout     !DON'T DO THIS!

NEVER issue the command “no exec-timeout” – instead it is much safer to use “exec-timeout 0″, because people make mistakes when typing “no exec-timeout” and end up with “no exec”, which means “do not run the Cisco IOS, for example Cisco 2900 exec under this setting”. It can be used as a way of totally disabling the AUX port, (under line aux 0) or even disabling telnet (under line vty 0 4)

line con 0  !(or line vty 0 4)
 exec-timeout 0     !Much safer

Comments

[Obat kutil kelamin]

I really like the information provided in this article. Installing solar panel will drastically reduce the green house gas emissions (carbon footprint) and electricity bill of ones house holds, Even though solar panel don’t emmidiately pay for themselves 5 to ten years they are still a very wise investment.

[Obat Sipilis]

Thanks for sharing your nice post

[Obat Wasir]

Thank's to information

[obat kencing nanah]

thanks for shared

[Obat kutil kelamin]

tanda dan gejala dari kutil kelamin