cisco 3560x

Let’s talk about VLANs today. Some time ago a friend of mine made me a question. If two PCs are connected to two different switches and they are in two different VLANs, however, the switches are connected to each other with access ports (each belonging...

Question:   In Lab , I have used two Cisco WS-C3560X-24T-L Switches.   I have created two vlans  Vlan2 and Vlan 3 on first Switch.   I have created two SVI on first switch and assign Ip address 10.10.20.1/24 and 10.10.30.1/24 respectively.   Host between...

We have just recently cut over from an older core switch/router platform (running CatOS 8.x) to a newer platform running IOS 15. So all the SVI's for our VLANs moved over from the old platform to the new, and a trunk link (4x1GB etherchannel) was configured...

I eventually solved a perplexing problem setting up telnet for a new switch. I installed a new Cisco WS-3560X-24P-S switch connected to an existing Cisco 4506 running a WS-X4013-10GE Sup II-Plus. After configuring vlans and trunking, I could not telnet...

I am running OpenIndiana (oi_151a8) and have two NICs aggregated using LACP connected to a Cisco WS-C3560X-24T-L. Both the server and the switch show the aggregate link as up. But while link layer traffic is visible ('snoop' shows ARP requests etc), I...

Please explain the password recovery enable procedures for WS-C3560X-24T-L The following procedures get to the switch: dir flash and get the following.....unable to stat flash//: no such device Can you please explain how to resolve this? Try the following...

I appear to have some fundamental misunderstanding of how VLANs work on Linux, and I'm hoping the good people here can educate me. Cast: One Cisco WS-C3560X-48T-L, one VLAN, and one Linux box [1]. Cisco --------------- Linux ge0/1 eth0 The Cisco has a...

You want to set to default configuration of cisco WS-C3560X-48T-S interface switches. In order to perform the procedures described in this document, you must have "enable" In certain situations, it is desirable to restore the Catalyst switch configuration...

VLAN Trunking Protocol VTP sends messages between trunked switches to maintain VLANs on these switches in order to properly trunk. VTP is a Cisco proprietary method of managing VLANs between switches and runs across any type of trunking mechanism. VTP...

Question: i just read the chapter about intervlan routing , i got no problem with legacy or router on a stick, but i can't understand how to configure a WS-C3560X-48T-L to route packets. i had tried a really easy topology on packet tracert , 2 pc on 2...