Cisco Switch Password Recovery

Published on by dellpe

This tutorial documents the procedure for performing a password recovery on a Cisco WS-C2960S-24TD-L switch (and probably other models, as well).


1. Unplug the power cable.

2. Hold down the mode button while replugging the power cable.

3. Type flash_init over the console.

4. Type load_helper

5. Type Dir flash :
//make sure to type the semi-colons

6. Type rename flash:config.txt flash:config.old
//the password is contained in the config.txt file

7. Type boot
//this reboots the system

8. Type n to skip the initial setup configuration.

9. Type enable
//this takes you to the enable mode

10. Type rename flash:config.old flash:config.txt

11. Save config.txt to system:
#copy flash:config.txt system:running-config

12. Enter config mode and change the password:
# config t
# no enable secret
//this applies only if the enable secret password was created

13. Finally, write the changes to memory:
# write memory

Published on Cisco Switch

Comment on this post

Obat Wasir 06/19/2015 09:44

Thanks for sharing your nice post

obat herpes manjur 11/28/2014 04:38

tkanks for shared

Obat kutil kelamin 11/20/2014 07:19

http://obatwasirdanambeienherbal.blogspot.com/2014/11/obat-ambeien-ampuh.html

Obat sipilis atau raja singa 05/16/2014 19:52

Please sahre this my post gan, thank

Cara Mengobati Sipilis 04/29/2014 06:38

Informasi yang anda berikan. tentu memberikan saya inspirasi.. terimakasih